AUTOMATIC STUD DRIVERS

	FULLY AUTOMATIC STUD DRIVERS WITH PROJECTION HEIGHT OR TORQUE CONTROL

LANCER SERIES®
Lancer^®series stud drivers are used to drive studs to a predetermined projection height. The fully automatic Lancer^® cuts cycle time by being pushed, not threaded onto the stud. When the cycle is complete the lancer^® is simply pulled away from the stud eliminating the added expenses associated with reversible spindles. Lancers^® can also be used in conjunction with torque control spindles for applications that specify a torque requirement, not a projection height. The lancer^® is the right choice for studs up to 7/16" (10MM) that are to be driven to projection height. The complete Lancer catalog in English. The complete Lancer catalog in German. The one page overview is still available by clicking here (185kb PDF)
SENTINEL SERIES^®
SENTINEL^® series stud drivers are used to drive studs to a pre-set torque limit. Like LANCERS^® the sentinel^® is fully automatic and save cycle time by being pushed, not threaded onto the stud. Sentinel^® stud drivers use a durable, highly reliable rolling element clutch mechanism which will last for many thousands of cycles. Choose the Sentinel^® for studs up to 7/16" (10MM) that are to be driven to torques up to 35 foot pounds (47NM). The complete Sentinel catalog is now available online. The one page overview is still available by clicking here (182kb PDF)
100 SERIES AUTOMATIC^®	191kb pdf
The 100 series automatic^® stud drivers have been on the market for well over 50 years. This time proven design offers the same great performance characteristics of the lancer but in a larger more robust package for applications that require higher installation torque or larger stud sizes. The 100 series automatic^® stud drivers have driven millions of studs to projection height in factories around the world. When driving studs of 3/8" (10MM) in diameter to projection height the 100 Series Automatic^® is the tool to choose.
100 SERIES CD^®	236kb pdf
Built with the same components as the 100 series Automatic^® stud drivers, the CD version also incorporates a durable clutch mechanism for applications that require studs to be driven to a torque not projection height specification. The 100 Series CD^® is the correct choice for studs above 3/8" (10MM) that are to be drive up to 225 foot pounds of torque (305NM)


Revised: 04/29/04