Lancer Series Micro-matic Stud Driver

Previous Page

Page 2 of 11

Click Here To Submit Your Application And Receive A Prompt Quote

RETURN TO TOP OF PAGE

RETURN TO HOME PAGE

CONTACT TITAN TOOL COMPANY

Revised: 08/22/03

Lancer® Series Micro-matic
Stud Driver

LANCER® Series Performance Options
	Centering Guide ● Use when studs are pre-started into workpiece ● Requires torque control in stud driver* or torque controlled power tool
	Posi-Load Stud Retainer ● For semi-automatic (hand loading) of stud into stud driver ● Requires torque control in stud driver* or torque controlled power tool ● May also be used for machine loading of stud (Ex. - shuttle plate)
	ML Machine Load Stud Retainer ● For fully automatic pre-loading of stud into stud driver ● Requires torque control in stud driver* or torque controlled power tool ● NOT recommended for hand loading
	#10 Gage ● For adjustable stud projection height ● Trips tool into "non-drive, free wheeling" mode when face of gage touches workpiece ● Not recommended when driving studs to shoulder or bottoming stud in hole ● Studs must be pre-started into workpiece
	#10 AL Auto-Load Gage ● For semi-automatic (hand loading) of stud into stud driver ● Trips tool into "non-drive, free wheeling" mode when face of gage touches workpiece ● May also be used as stud retention device on torque controlled application with longer studs (If so, gage MUST NOT touch workpiece before required torque is reached.)
	#10 ML Machine Load Gage ● For fully automatic pre-loading of longer studs into stud driver. (Ex. Picking studs up from shuttle plate with ML gage provides superior concentricity of stud as workpiece is approached.) Not recommended for semi-automatic use (pre-loading by hand). ● May be used as trip gage for automatic projection OR used only as stud retention device on torque controlled application if stud length permits
	#11 thru #15 Gages ● Use same as #10 Gage, but for increasingly longer stud projections
	#11 AL thru #15 AL Gage ● Use same as #10 AL Gage, but for increasingly longer stud projections - SPECIAL TO ORDER -
	#11 ML thru #15 Gage ● Use same as #10 ML Gage, but for increasingly longer stud projections - SPECIAL TO ORDER -
	#1 Open Gage ● Use same as #10 Gage on studs with extremely short stud projections CAUTION: O.D. of workpiece must be greater than 25/32" (19.8mm) when used on Lancer-1 or greater than 1-7/32" (30.95mm) when used on Lancer-2.
Titan SENTINEL* has an adjustable torque clutch. LANCER does NOT.